Toystorybirthdaysupplies

WALL - WHAT IS IT? How to solve? Humidity PROTEC

What is MOISTURE FOUNDATION?

is the one that arises from the floor, climbing the walls, the floors also evidensiandose, blistering and peeling paint, staining, and finally peeling wallpaper plaster, damaged furniture, carpets and clothing. The foundation moisture usually reaches 10 to 30 cm above the floor but on occasion more than 2 meters tall. The problem is associated with the smells of damp, cold and ill health of those living in the household, especially children and the humidity is much higher up to 1 meter in height.

chemical injection system

STAGE:

holes were drilled 25 to 30 mm in diameter (each 7 cm.) Through the wall in 75% thickness. This is done by machine (rotopercutoras electro pneumatic) heavy-duty drilling all types of wall. You can verify the boundaries environments determining at what level will carry out the drilling. In case of party walls, the technician must perform a visual inspection of the adjoining room. PROTEC technician will measure the moisture in the wall determine whether the injection process is running on the same day or whether to leave the wall to dry a few days to try *. As well as the need to drill or not a strip of plaster, either by deterioration or by its quality as an important factor in treatment outcome. The moisture content should not exceed 20% for absorption during the injection is effective. When the moisture content should be the minimum, could be shifted to the second stage.

* If the wall is impregnated with moisture, the drying process can be accelerated by heat and / or ventilation.

STAGE :

Carefully inject the product (siliconates and silicate solution) using special peak filling pressure the boreholes, the measured amounts are needed to saturate the entire thickness in each wall. This stage is carefully controlled by PROTEC technician, who will provide enough doses operators so that the wall is completely impregnated by capillary after 24 Hrs The wall will be completely impermeable to moisture permeability ascending air Able thus allowing the same breath.

The solution used is made from imported raw material from WACKER ® Germany.

In construction, these products are most effective to stop the passage of moisture and especially in highly absorbent materials such as common brick.

The injected product will be the necessary and appropriate for each type of wall.